Muratec MFX-2050 Field Engineering Manual page 143

Memory Switch 020 — Reception
Initial
Switch
Setting
7 0
6 0
 
5 0
4 0
3 1
 
2 1
1 0
0 1
Memory Switch 021 — Reception
Initial
Switch
Setting
7 0
6 0
5 0
4 0
 
3 1
2 0
 
1 0
 
0 1
Memory Switch 022 — Factory use only
Adjust
Data error rate
0: 10%
1: 20%
Pause one second after
sending CED
0: No (75 ms)
1: Yes (1 sec)
Factory use only
Factory use only
Receive speed (kbps)
Maximum receive speed may be slowed to compensate for poor phone lines.
2.4 4.8 7.2 9.6 12 14.4 16.8 19.2 21.6 24 26.4 28.8 31.2 33.6
0 0 0 0 0 0
0 0 0 0 1 1
0 0 1 1 0 0
0 1 0 1 0 1
Adjust
Not used
DIS inch declaration
0 : Yes
1 : No
Paper size limitation
0: No limit
1: 3m
T1 timer
0: 35 sec
1: 20 sec
Print image data when post
message is not received after
receiving RTC signal
0: No
1: Yes
DIS/DTC Extend field
Transmit
0: Yes
1: No（Tx until Bit No.24 of
DIS/DTC）
G3 echo receive
Adjusts the delay between detection of training/TCF and sending of CFR.
100 ms 500 ms 800 ms 1200 ms
Switch 1 0 0
Switch 0 0 1
Usage/Comments
Determines the allowable number of erred lines out
of total lines received in a document.
A 2100 Hz CED signal disables echo suppression
in some telephone equipment. When set to "1", the
machine pauses one second after sending CED,
which allows echo suppression to restart. This may
help with problematic overseas reception.
0 0 1 1 1
1 1 0 0 0
1 1 0 0 1
0 1 0 1 0
Usage/Comments
This will limit the paper length of the received
document. Setting this bit to "1", the paper will be
cut when the length reached to 3m.
Adjusts the T1 time-out. After the machine dials
the remote machine's phone number, it begins
sending CNG and waits this amount of time before
disconnecting the line.
If the received document includes the RTC, the
machine prints the data even though the following
protocol is not succeeded.
Setting this switch to "1" will disable ITU-T superfine
mode.
1 1
0 1
3-59
1 1 1
0 1 1
1 0 0
1 0 1