Muratec MFX-2050 Field Engineering Manual page 167

Unique Switch 015 — Transmission
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Not used
4 0 Factory use only
3 0 Factory use only
2 1 Factory use only
1 1 Factory use only
0 1 V.8 handshake in manual Tx
0: No
1: Yes
Unique Switch 016 — Transmission
Initial
Switch
Setting
7 1 Available *, # and space
upon F-code box registration
0: No
1: Yes
Available *, # and space
upon F-code communicating
6 1
0: No
1: Yes
5 0 Ignore space in F-code ID
0: Yes
1: No
4 1 F-code sub-frame off
0: Send
1: Not send
3 0 Send F-code box's TTI
0: No
1: Yes
2 0 Factory use only
1 0 Retrieve document
0: No
1: Yes
0 1 Ignore F-code bit
0: No
1: Yes
Note: The "F-code communication" is possible the SecureMail and Polling operation using the F-code
(SUB/SEP/PWD/SID). However, it is not based on T.33 recommendation.
Adjust
Determine I the handshaking will be done with V.8
recommendation if manual transmission.
Adjust
Determines if the * (asterisk), # (sharp) and space
are available upon F-code box registration.
Determines if the * (asterisk), # (sharp) and space
are available upon F-code communicating.
Determines if checking the space stored in the
F-code ID.
Do not send the sub-address and password of
F-code box when a point of sending DCS signal
after EOM signal.
Transmit the sub-address and box name of F-code
box with F-code polling document.
Retrieve the document received in F-code
SecureMail box by polling transmission.
Neglect SEP bit of DTC signal or SUB bit of DCS
signal at F-code polled transmission.
3-83
Usage/Comments
Usage/Comments