The Wps Screen - ZyXEL Communications AMG1302-T series User Manual

Table 22 Network Setting > Wireless > MAC Authentication (continued)
LABEL
Add new MAC
address
#
MAC Address
Modify
Apply
Cancel

7.5 The WPS Screen

Use this screen to configure WiFi Protected Setup (WPS) on your AMG1302/AMG1202-TSeries.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See
Note: The AMG1302/AMG1202-TSeries applies the security settings configured in the
General screen (see
make sure you have set the security mode to WPA2-PSK or No Security.
Click Network Setting > Wireless > WPS. The following screen displays. Select Enable and click
Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
AMG1302/AMG1202-TSeries User's Guide
DESCRIPTION
Click this if you want to add a new MAC address entry to the MAC filter list below.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the
AMG1302/AMG1202-TSeries in these address fields. Enter the MAC addresses in a valid MAC
address format, that is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
This is the index number of the entry.
This is the MAC addresses of the wireless devices that are allowed or denied access to the
AMG1302/AMG1202-TSeries.
Click the Delete icon to delete the entry.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
Section 7.10.8.3 on page 115
Section 7.2 on page
for more information about WPS.
92). If you want to use the WPS feature,
Chapter 7 Wireless LAN
101