ZyXEL Communications AMG1302-T series User Manual page 32

Chapter 3 Internet / Wireless Setup Wizard
The following table describes the fields in this screen.
Table 4 Internet Connection with ENET ENCAP
LABEL
Encapsulation
Multiplex
VPI
VCI
Select Yes to enter specific IP information from your Internet service provider.
your Internet access information exactly as your service provider gave it to you.
IP Address
Subnet Mask
Default
Gateway
Primary DNS
Server
Secondary
DNS Server
Back
Apply
Exit
32
DESCRIPTION
Select the encapsulation type your ISP uses from the Encapsulation
drop-down list box: IPoA, ENET ENCAP, PPPoA, or PPPoE.
Select the multiplexing method used by your ISP from the Multiplex
drop-down list box either VC-based or LLC-based.
Enter the Virtual Path Identifier (VPI) assigned to you. This field may
already be configured.
Enter the Virtual Channel Identifier (VCI) assigned to you. This field may
already be configured.
Enter the IP address of the AMG1302/AMG1202-TSeries.
Enter the subnet mask in dotted decimal notation.
Refer to the appendix to calculate a subnet mask if you are implementing
subnetting.
You must specify a gateway IP address (supplied by your ISP) when you
use ENET ENCAP in the Encapsulation field in the previous screen.
Enter the primary DNS server IP address for the AMG1302/AMG1202-
TSeries.
Enter the secondary DNS server IP address for the AMG1302/AMG1202-
TSeries.
Click this to return to the previous screen without saving.
Click this to save your changes.
Click this to close the wizard screen without saving.
Enter
AMG1302/AMG1202-TSeries User's Guide