ZyXEL Communications AMG1302-T series User Manual page 102

Chapter 7 Wireless LAN
Figure 34 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 23 Network Setting > Wireless > WPS
LABEL
General
WPS
Add a new device with WPS Method
Method 1 PBC
WPS
Method 2 PIN
102
DESCRIPTION
Select Enable to activate WPS on the AMG1302/AMG1202-TSeries. Otherwise, select
Disable to deactivate WPS.
Use this section to set up a WPS wireless network using Push Button Configuration
(PBC).
Click this button to add another WPS-enabled wireless device (within wireless range of
the AMG1302/AMG1202-TSeries) to your wireless network. This button may either be a
physical button on the outside of device, or a menu button similar to the WPS button on
this screen.
Note: You must press the other wireless device's WPS button within two minutes of
pressing this button.
Use this section to set up a WPS wireless network by entering the PIN of the client into
the AMG1302/AMG1202-TSeries.
AMG1302/AMG1202-TSeries User's Guide