ZyXEL Communications AMG1302-T series User Manual page 130

Chapter 8 Home Networking
LABEL
Router Lifetime
Router Preference
Reachable Time (ms)
Retrans Timer (ms)
RA Interval
Delegate MTU from
WAN
Manual
MTU
DAD attempts
DHCPv6
DHCPv6 Server
DNSv6 Mode
Primary DNS
Secondary DNS
Information refresh
time
Apply
Cancel
130
DESCRIPTION
Enter the time in seconds that hosts should consider the AMG1302/AMG1202-TSeries
to be the default router. Possible values for this field are 0-9000.
Select the router preference (Low, Medium or High) for the AMG1302/AMG1202-
TSeries. The AMG1302/AMG1202-TSeries sends this preference in the router
advertisements to tell hosts what preference they should use for the AMG1302/
AMG1202-TSeries. This helps hosts to choose their default router especially when
there are multiple IPv6 router in the network.
Note: Make sure the hosts also support router preference to make this function work.
Enter the time in milliseconds that can elapse before a neighbor is detected. Possible
values for this field are 0-3600000.
Enter the time in milliseconds between neighbor solicitation packet retransmissions.
Possible values for this field are 1000-4294967295.
Enter the time in seconds between router advertisement messages. Possible values for
this field are 4-1800.
Select this to have the AMG1302/AMG1202-TSeries obtain the MTU setting from the
service provider or uplink router.
Select this to specify the MTU manually.
The Maximum Transmission Unit. Type the maximum size of each IPv6 data packet, in
bytes, that can move through this interface. If a larger packet arrives, the AMG1302/
AMG1202-TSeries divides it into smaller fragments.
Specify the number of DAD (Duplicate Address Detection) attempts before an IPv6
address is assigned to the AMG1302/AMG1202-TSeries LAN interface. Possible values
for this field are 1-7.
Use this field to Enable or Disable DHCPv6 server on the AMG1302/AMG1202-
TSeries.
Select the DNS role (Proxy or Relay) that you want the AMG1302/AMG1202-TSeries
to act in the IPv6 LAN network. Alternatively, select Manual and specify the DNS
servers' IPv6 address in the fields below.
This field is available if you choose Manual as the DNSv6 mode. Enter the first DNS
server IPv6 address the AMG1302/AMG1202-TSeries passes to the DHCP clients.
This field is available if you choose Manual as the DNSv6 mode. Enter the second DNS
server IPv6 address the AMG1302/AMG1202-TSeries passes to the DHCP clients.
Enter the number of seconds a DHCPv6 client should wait before refreshing
information retrieved from DHCPv6.
Click this to save your changes.
Click this to restore your previously saved settings.
AMG1302/AMG1202-TSeries User's Guide