The Wmm Screen - ZyXEL Communications AMG1302-T series User Manual

Chapter 7 Wireless LAN
Note: At the time of writing, WDS is compatible with other ZyXEL APs only. Not all models
support WDS links. Check your other AP's documentation.
Click Network Setting > Wireless > WDS. The following screen displays.
Figure 35 Network Setting > Wireless > WDS
The following table describes the labels in this screen.
Table 24 Network Setting > Wireless > WDS
LABEL
WDS Security
TKIP
AES
#
Active
Remote Bridge
MAC Address
PSK
Apply
Cancel

7.7 The WMM Screen

Use this screen to enable WiFi MultiMedia (WMM) and WMM Power Save in wireless networks for
multimedia applications.
104
DESCRIPTION
Select the type of the key used to encrypt data between APs. All the wireless APs
(including the AMG1302/AMG1202-TSeries) must use the same pre-shared key for data
transmission.
The option is available only when you set the security mode to WPA(2) or WPA(2)-
PSK in the Wireless > General screen.
Select this to use TKIP (Temporal Key Integrity Protocol) encryption.
Select this to use AES (Advanced Encryption Standard) encryption.
This is the index number of the individual WDS link.
Select this to activate the link between the AMG1302/AMG1202-TSeries and the peer
device to which this entry refers. When you do not select the check box this link is down.
Type the MAC address of the peer device in a valid MAC address format (six hexadecimal
character pairs, for example 12:34:56:78:9a:bc).
Enter a Pre-Shared Key (PSK) from 8 to 63 case-sensitive ASCII characters (including
spaces and symbols).
Click this to save your changes.
Click this to restore your previously saved settings.
AMG1302/AMG1202-TSeries User's Guide