Continuous Write (Write 2) - Omron SYSMAC C200H-IDS01-V1 Operation Manual

Monitoring
3-2-7

Continuous Write (WRITE 2)

start
address/
data setting
WRITE
Normal
completion
When an
error occurs
RESET
64
This operation continuously writes several bytes of the same data to a speci-
fied address range in the Data Carrier. Refer to the following figure.
Before performing this operation, select the address and the data you want to
write. Refer to 3-2-4 Address/Data Setting for details.
HEAD 1 PAGE 1
STadrs1F data 54
ST: start address
ED: end address
start address ≥ end address
HEAD 1 PAGE 1
2
CWadrs1F data 54
Indicates that Continuous
Write will be executed.
HEAD 1 PAGE 1
CWadrs28 data 54
HEAD 1 PAGE 1
CWadrs3F data 54
End address
HEAD 1 PAGE 1
CWadrs32 NO DC E
Address at which an
error has occurred
HEAD 1 PAGE 1
CWadrs1F data 72
Error code number
HEAD 1 PAGE 1
STadrs1F data 54
Data to
be written
start
address
Data to be written
Error
message
or
Select the start and end ad-
dresses, as well as the data
to be written.
Press the WRITE 2 key.
"CW" is displayed in the low-
er left corner of the Pro-
gramming Console display,
indicating that Continuous
Write is being executed. The
data is written to the
addresses in the range spe-
cified.
When the data is written cor-
rectly to all addresses and the
Continuous Write operation is
completed, the written data
appears as shown in the
example.
If an error occurs during the
Continuous Write operation,
the buzzer sounds for 2
seconds, and an error mes-
sage is displayed (refer to
) .
3-2-10 Error Codes
Pressing the left or right
arrow key will toggle the dis-
play between the error mes-
sage and the corresponding
error code.
To perform another opera-
tion or abort the Continuous
Write operation, press the
RESET key, and the display
will return to reset status. In
this example, the display
indicates the reset status.
Another operation can now
be performed.
Section 3-2