Omron SYSMAC C200H-IDS01-V1 Operation Manual page 70

Monitoring
Monitor command
Error log display Use this command to display
errors that occurred while the
ID Sensor was in RUN mode.
Error messages and
corresponding codes are
displayed, and errors are
classified as either "newest
error" or "statistical error".
Initial Display
<MONITOR>
RESET Display
C200H-IDS01-V1
The number of the
Read/Write Head
connected to the
ID Sensor Unit.
Usually fixed to 1.
(See notes below.)
HEAD 1 PAGE 0A
RESET
STadrs00 data 00
Address
ST: Start address
ED: End address
Function
When the mode selector is in the MONITOR mode, the following message is
displayed:
BZ
Note When the Programming Console is in MONITOR mode and the buzzer is
enabled, only the following keys are functional:
RESET DATA
Press the RESET key to return the screen to RESET status. Press the
RESET key either after a monitoring operation has been completed, or during
a monitoring operation to abort that operation.
The following message is displayed when the RESET key is pressed:
Address page number
(Refer to Address Page
Numbers below.)
Data
1
ERR
2
3
4
1
2
3
4
Indicates that the buzzer is enabled.
Press the "B" key to alternately enable or
disable the buzzer.
B
ADRS JOB
C200H-IDS21
The number of the
Read/Write Anten-
na connected to
the ID Sensor Unit.
Usually fixed to 1.
(See notes below.)
HEAD 1 PAGE 00
RESET
STadrs00 data 00
Address
ST: Start address
ED: End address
Key sequence
INC
DEC
SET
(Date change)
SET
: displays newest error information
: displays statistical error information
: clears newest error information
: clears statistical error information
Address page number
(Refer to Address Page
Numbers below.)
Data
Section 3-2
SET
55