Chapter 5 Mounting The Router; General Safety Information For Mounting; Contents Of The Mounting Kits; Pole Mount Kit - Cisco 1240 Hardware Installation Manual

General Safety Information for Mounting

Cisco Product ID (PID)
CGR-PMK-BAND
AIR-BAND-INST-TL=
General Safety Information for Mounting
Before performing any of the tasks in this chapter, read the safety warnings in this section and in the
"Installation Safety and Site Preparation" section on page
One person is required to properly and safely mount the router.
All mounting methods at any location are subject to the acceptance of local jurisdiction.
Caution
The mounting surface, attaching screws, and optional wall anchors must be able to support a
Caution
50 pound (22.7 kg) static weight.
Personnel mounting the router must understand grounding methods.
Caution
Do not locate the antenna near overhead power lines or other electric light or power circuits, or
Warning
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death. For proper
installation and grounding of the antenna, please refer to national and local codes (for example,
U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical Code, Section 54).
Statement 1052

Contents of the Mounting Kits

This section describes the contents of the mounting kits available for the router and when you should use
each kit.

Pole Mount Kit

When to Use
Use the Cisco pole mount kit to install the mounting plate on any pole or streetlight. The kit supports
poles that meet the following criteria:
•
Cisco 1240 Connected Grid Router Hardware Installation Guide
5-2
Name
Band Strap Kit,
page 5-5
Strap Tool Kit,
page 5-6
Size—2 to 16 inch diameter poles
Description
This kit includes two steel straps for mounting the router
on poles larger than 4.5 inches (11.4 cm) in diameter. This
kit is used together with the
Tool is required to install the steel straps on a pole.
This kit includes a BAND-IT tool that is required when
using steel straps to install the router on poles larger than
4.5 inches (11.4 cm) in diameter.
2-1.
Chapter 5 Mounting the Router
Pole Mount Kit. A BAND-IT
OL-26223-04