Cisco Ios Battery Backup Commands; Battery Charge-Discharge - Cisco 1240 Hardware Installation Manual

Chapter 12 Installing Battery Backup Units
By default, all modules continue to operate normally when the router is powered by the BBU. Enter this
command for each module that you want to automatically shut down.
Syntax
poweroff module number backup-battery Configures the router to power down the indicated
To configure the router to shut down the Ethernet switch (all Ethernet ports) when the router is powered
by the BBU, enter this command:
CGR1240(config)# poweroff module 2 backup-battery
To configure the router to shut down the module installed in Slot 6 when the router is powered by the
BBU, enter this command:
CGR1240(config)# poweroff module 6 backup-battery
Use the no form of the command to reset a module to the default behavior: continue to operate normally
when the router switches to BBU power. For example:
CGR1240(config)# no poweroff module 2 backup-battery
For detailed information on configuring the router, including configuration modes and saving
configurations, see the router software configuration guides on Cisco.com, at:
www.cisco.com/go/cgr1000-docs

Cisco IOS Battery Backup Commands

•
•
•

battery charge-discharge

The battery charge-discharge command only works on routers using the Cisco IOS operating system.
Note
When the BBU discharge is disabled by the battery charge-discharge disable command, the BBU does
Note
not charge, even if it is connected to AC power. The BBU discharge must be enabled by the battery
charge-discharge enable command, and the BBU connected to AC power, for the BBU to charge.
To change the enabled status of the BBU automatic discharge feature, use the battery charge-discharge
command in user EXEC mode. The command syntax is:
OL-26223-04
battery charge-discharge, page 12-27
show platform battery, page 12-28
show environment power, page 12-33
Description
module when the router switches to BBU power.
number—The number of module that is powered down:
• 2: Ethernet switch module (all ports)
• 3-6: Module inserted in the slot with corresponding
number. Slot numbering is described and illustrated
in the "Router Hardware Description"
Cisco 1240 Connected Grid Router Hardware Installation Guide
Related Commands
chapter
.
12-27