Cisco 1240 Hardware Installation Manual page 130

Installing Modules in the Router
Use the screwdriver to remove the faceplate that covers the empty module slot.
Step 3
Align the module edge with the slot edge guide and insert the module in the router module slot until fully
Step 4
seated in the connector. (See
Use the screwdriver to tighten the captive module mounting screws (two per module) into the connectors
Step 5
on the router front panel. Torque to 10 to 12 inch-pounds.
Step 6 Attach any required cables to the module. This step is specific to the module type.
Refer to the installation and configuration guide for the module, at
Note
Close the router door, following the steps in the
Step 7
Connect the router to AC power and to the network, following the steps in the
Step 8
chapter.
Step 9 Re-enable the BBU using the commands in the Related Commands section of the
Backup Units"
Figure 9-1
Slot 3 - 3G Module
Slot 4 - WPAN Module
Cisco 1240 Connected Grid Router Hardware Installation Guide
9-4
Figure 9-1.)
chapter.
Insert Modules into Router
Chapter 9
www.cisco.com/go/cg-modules.
"Opening the Router Chassis"
Connected Grid Modules
chapter.
"Installing the Router"
"Installing Battery
Slot 6 - WiMAX Module
1
3
2
4
OL-26223-04