Cisco 1240 Hardware Installation Manual page 104

Basic Hardware Installation
Serial0 is administratively down, line protocol is down
Hardware is HD64570
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0 (size/max/drops); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/64/0 (size/threshold/drops)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
For more information about using the show interface command, see the router configuration guide on
Cisco.com, at:
Example: show interface Command Output for Cisco IOS
The output from the show interface command shows that the router Ethernet interface is up in the first
line of the command out put.
GigabitEthernet0/1 is up, line protocol is up
Hardware is iGbE, address is 0022.bdec.f0f9 (bia 0022.bdec.f0f9)
Internet address is 192.168.1.254/24
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto Duplex, Auto Speed, media type is internal
output flow-control is unsupported, input flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:06:39, output 00:00:06, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Dot11Radio2/1 is administratively down, line protocol is down
Hardware is 802.11N 2.4GHz Radio, address is 5cda.d4ad.092a (bia 5cda.d4ad.092a)
Cisco 1240 Connected Grid Router Hardware Installation Guide
6-10
0 babbles, 0 late collision, 1474 deferred
19 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Conversations 0/0 (active/max active)
Reserved Conversations 0/0 (allocated/max allocated)
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
DCD=down DSR=down DTR=down
www.cisco.com/go/cgr1000-docs.
reliability 255/255, txload 1/255, rxload 1/255
8579 packets input, 612922 bytes, 0 no buffer
Received 994 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 497 multicast, 0 pause input
58519 packets output, 6541254 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
1 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
RTS=down CTS=down
Chapter 6 Installing the Router
OL-26223-04