Mounting The Router On A Wall - Cisco ASR 901 10G Series Hardware Installation Manual

Chapter 3 Installing the Cisco ASR 901 10G Router
For the best support of the router and cables, make sure that the switch is attached securely to wall studs
or to a firmly attached plywood mounting backboard.
Perform the steps given below:
Read the wall-mounting instructions carefully before beginning installation. Failure to use the
Warning
correct hardware or to follow the correct procedures could result in a hazardous situation to people
and damage to the system. Statement 378
Step 1 Locate the position where you plan to install the router.
Ensure that there are no obstructions.
Step 2
Position the router with the ports facing up as in
Step 3
the holes on the wall and secure with four Number 6-32 x 0.25-inch mounting screws (two on each side).
Tighten the screws using a 1/4-inch flat-blade screwdriver (each side).
Step 4
Figure 3-6
1 User-supplied screws
OL-28105-02

Mounting the Router on a Wall

Cisco ASR 901 10G Series Aggregation Services Router Hardware Installation Guide
Mounting the Cisco ASR 901 10G Router
Figure 3-6, or down and align the bracket holes with
1
2 —
3-9