Related Information - Cisco 1240 Hardware Installation Manual

Related Information

To connect the module to power, follow these steps:
Verify that the module power cable is threaded through the router cable port, and that the cable port has
Step 1
cable glands or an O-ring installed.
Connect the power cable to the Micro-Fit 3.0 power connector. See in
Step 2
location.
Figure 13-4 Cable Harness and Power Connector
1
2
Related Information
This chapter describes installation procedures. For detailed, technical information about the router
hardware, including connector and cable descriptions, specifications, and pinouts, see the following
chapters:
•
•
Cisco 1240 Connected Grid Router Hardware Installation Guide
13-10
The "Router Hardware Description"
the ports and cable glands described in this chapter.
The "Connector and Cable Specifications"
connector used to provide power to non-Cisco modules.
Chapter 13
chapter describes all features of the router hardware, including
appendix includes the pinouts for the 12V power
Installing External Non-Cisco Modules
in Figure 13-4 for connector
2
OL-26223-04