Power And Reset Buttons - Cisco 1240 Hardware Installation Manual

Chapter 6 Installing the Router
Figure 6-5
Item
1

Power and Reset Buttons

There are two reset buttons inside the router chassis. See
are used to reset the router power and software configuration. They are not used to power the router on
and off; the router powers on immediately when it is connected to an AC power source.
Caution When you use the CONFIG Reset button to restore the router to the factory default software
configuration, the current software configuration is permanently deleted from the router.
•
•
The topics in this section include:
•
•
OL-26223-04
AC Connector Notch
Description
AC connector notch
CONFIG Reset—Press the CONFIG Reset button for at least 5 seconds to return the router
software configuration to the factory default, and power cycle the router. Power cycling the router
turns the router off, then immediately back on. The router will temporarily stop operating on the
network during the power cycle, then resume operating when the power cycle process is complete.
PWR RESET—Press the PWR RESET button for at least 5 seconds to power cycle the router.
Power cycling the router turns the router off, then immediately back on. The router will temporarily
stop operating on the network during the power cycle, then resume operating when power cycle
process is complete.
Accessing the Buttons, page 6-8
Related Information, page 6-8
1
Figure 3-15
Cisco 1240 Connected Grid Router Hardware Installation Guide
Basic Hardware Installation
for button locations. These buttons
6-7