Closing The Door - Cisco 1240 Hardware Installation Manual

Opening the Router Door
The door gasket creates a seal when the door is closed, so the door might open suddenly when the last
Caution
bolt is loosened.

Closing the Door

Verify that the door seal is clean and that all cables are tucked back into the chassis.
Step 1
Step 2 To close the door, use the socket wrench to evenly tighten all six bolts in the order shown in
Step 3 Evenly tighten the bolts again, in the order shown in
torque.
Step 4 Replace any locking mechanism, such as a padlock, on the door lock post.
Figure 4-3
Cisco 1240 Connected Grid Router Hardware Installation Guide
4-4
Captive Bolt Detail
Chapter 4
Figure 4-2, this time using 6 to 7 foot-pounds of
Opening the Router Chassis
Figure 4-2.
OL-26223-04