Installing A Module In An Online Router; Removing A Module From An Offline Router - Cisco 1240 Hardware Installation Manual

Chapter 9 Connected Grid Modules
Item
1
2
3
4

Installing a Module in an Online Router

The Cisco Connected Grid Device Manager (Device Manager) is used to install a module in an online
router. Device Manager is a Windows-based application that field technicians can use to manage the
Cisco 1000 Series Connected Grid Routers (CGR 1000) over WiFi or Ethernet.
Note The Device Manager can only be used on routers using the Cisco CG-OS operating system. It will not
work on routers using the Cisco IOS operating system.
For routers using the Cisco IOS operating system, modules must be installed when the router is offline.
For instructions on how to install a module in an online router, see the "Manage Modules" and "Add a
Note
Module" sections in the "Using the Device Manager" chapter of the Cisco Connected Grid Device
Manager Installation and User Guide on Cisco.com.
This is a general installation procedure for installing modules in the chassis of an online router. For
Note
hardware installation and software configuration steps that are specific to your module, see the
installation and configuration guide for the module, at:

Removing a Module from an Offline Router

To remove a module from an offline router:
Disconnect the router from AC power and disable any installed battery backup units by following the
Step 1
steps in the
Step 2 Open the chassis door by following the steps in the
Remove any antenna cables that are connected to module. This step is specific to the module type.
Step 3
Refer to the installation and configuration guide for the module, at
Note
Use the screwdriver to loosen the module captive screws (two per module) from the connectors on the
Step 4
router front panel.
OL-26223-04
Description Quantity
Module guide edge Slide module guide edge along the module guide (inside the slot)
when inserting module.
Captive screws Two captive screws hold each module (and module slot cover) in
place in the module slot.
Slot module guide Slide module guide edge along the module guide (inside the slot)
when inserting module.
Module slot cover Module slots WITHOUT modules installed should be covered with
a module slot cover.
"Powering Off the Router"
www.cisco.com/go/cg-modules.
chapter.
"Opening the Router Chassis"
Cisco 1240 Connected Grid Router Hardware Installation Guide
Installing Modules in the Router
chapter.
www.cisco.com/go/cg-modules.
9-5