Cisco 1240 Hardware Installation Manual page 177

Chapter 12 Installing Battery Backup Units
To display battery data information, use the show platform battery command in user EXEC mode. The
command syntax is:
show platform battery [brief | cable | details | short | sprom | unit]
Syntax Description:
brief
cable
details
short
sprom
unit
The following are examples of the command, with sample output:
CGR1240# show platform battery
Battery is not present
Battery pack state: Not available
The command output indicates a battery is not present.
CGR1240# show platform battery brief
Battery level 92% (12:27), Idle
The command output indicates that the battery is charged to a 92% level, has q2 hours and 27 minutes
battery life available, and is in an idle state.
CGR1240# show platform battery cable
Status register
OL-26223-04
(Optional) Displays summary information about the battery charge level in
percentage and hours:minutes formats, as well as the battery charge state:
Idle, if > 85%
•
Charging, if voltage > 10.5 V and charge value < 85%.
•
Discharging, if battery is main source of power.
•
Empty, if battery is drained out of charge.
•
(Optional) Displays details about the battery cable status:
present = 0, in the command output means that a battery cable is not
•
present.
present = 1, in the command output means that a battery cable is
•
present.
(Optional) Displays troubleshooting information about the battery by
presenting a range of summary information about the battery
characteristics.
(Optional) Displays backup battery information in short format (formatted
for a management device).
(Optional) Displays troubleshooting information based on the eeprom
details of the battery unit.
(Optional) Displays a range of battery charge, capacity, and parameter
information including:
battery charge state and charge value/level in percent.
•
capacity (remaining and full charge).
•
voltage and current levels.
•
firmware version details.
•
0x16
Cisco 1240 Connected Grid Router Hardware Installation Guide
Related Commands
12-29