Install The Mounting Plate Onto A Pole; Install The Mounting Plate-Poles Up To 4.5 Inches In Diameter - Cisco 1240 Hardware Installation Manual

Mounting Instructions

Install the Mounting Plate onto a Pole

This section describes three different procedures for installing the mounting plate on a pole. Follow the
instructions for the pole type used in your installation.
The instructions in these section refer to the mounting plate features shown in
•
•
•
Figure 5-5
1
2
3
Item
1
2
3
4
5
Install the Mounting Plate—Poles Up to 4.5 Inches in Diameter
To install the mounting plate on a vertical pole up to 4.5 inches (11.4 cm) in diameter, follow these steps
and refer to
Cisco 1240 Connected Grid Router Hardware Installation Guide
5-8
Install the Mounting Plate—Poles Up to 4.5 Inches in Diameter, page 5-8
Install the Mounting Plate—Poles Larger than 4.5 Inches in Diameter, page 5-10
Install the Mounting Plate—Through-Pole Mounting (Optional), page 5-11
Mounting Plate Details
Description
Carriage bolt holes
Bracket mount holes
Clearance holes, 3/4 in.
Pole clamp notches
Steel band strap slots
Figure 5-6 and Figure
Reverse angle
Qty.
4
8
2
2
4
5-7.
Chapter 5 Mounting the Router
Figure 5-5.
4
5
4
OL-26223-04