Ricoh Aficio FX10 Operator's Manual page 182

SETTING UP
Sharing the Printer
Sharing the Printer
If you have installed as a Server but do not wish to share the printer, then skip
this section.
Before a Client can print to the OfficeStyler T1 O printer, the sewer printer must
be shared and the client must be one of authorized users of the server.
The Server must share the printer resource. To share a printer resource the
Sewer must perform the following steps:
c1
Double-click the "Printer console" icon in the OfficeStyler T1 O Tools.
(Windows 3.x)
Click the "Start" button, point to "OfficeStyler T1 O Tools" in "Programs",
and then click "Printer Console". (Windows 95)
M
Click the "Control Panel" tab or select the Network menu.
H
Select "Share Printer".
n
, Check item(s) you are going to share. (i.e. GDI, PCL).
H
Select "OK". Printer sharing will be established automatically every time
Windows starts up.
Note:
Only one OfficeStyler TI O printer can be attached to any given PC. Therefore,
the Share command automatically selects the attached OfficeStyler TI O
printer at the Server's PC. If an additional non- OfficeStyler TI O printer is also
attached to the Server's PC then to share that printer the Server uses the
Share menu item in the Network menu of the Windows Print Manager.
To stop sharing printer resource
To stop sharing printer resource, perform the following steps:
c1
Double-click the Printer console icon in the OfficeStyler TIO Tools.
(Windows 3.x)
Click the "Start" button, point to "OfficeStyler T1 O Tools" in "Programs",
and then click "Printer Console". (Windows 95)
16