Toshiba DK14 Programming Manual page 38

Initialization & Test
Program 92 – Initializing Misc. Backup RAM
Program 92-9 does not affect Call Forward External or Fixed Call Forward settings.
G
You must power the system Off then back On to clear telephone LCD Call Forward Displays
G
and Call Forward button LEDs. Call Forward memory is cleared when you run Program 92-9,
even if system power is not cycled.
Program 92 Example
1. Use the programming LCD electronic or digital telephone. (See
1: Check Minimum Hardware Requirements" on Page
✱ ✱ ✱ ✱
2.
Enter programming mode. (Do not press [DN] button.) System beeps
after
be entered.
3.
Access Program 92.
4.
Prepare the system for selection of programs to initialize. For new
system installation perform all 1~4.
Select one of the following.
5.
+ LED Buttons 01 & 03
Clears Station Speed Dial, Voice Mail ID codes, and LCD memos
assigned to station speed dial numbers.
or...
+ LED Buttons 01 & 04
Clears System Speed Dial and LCD memos assigned to system
speed dial numbers.
or...
+ LED Buttons 02 & 03
Clears Character Message Memory (station and system) and user
name display.
or...
+ LED Buttons 02 & 04
Clears timed reminders.
or...
+ LED Buttons 01 & 05
Presets the Ring, Speaker, Mute Ring, and Intercom Tone, BGM,
volume levels of all digital telephones to approximately mid-range.
or...
+ LED Buttons 03 & 04
Clears Call Forward and Message Waiting (R3) Memory except Fixed
Call Forward Memory.
6.
LEDs lit in Step 5 turn off to secure data in system programming.
Repeat Steps 4~6 until Step is completed.
1. N-N is the Program Telephone [DN].
2-10
Action (press buttons + LED Buttons)
is pressed to indicate program number may
"Step
1-14.)
Jan 20 Sun
Program Mode
Program = 92
92 Select =
92 Select = 1
Each Dial Clr
92 Select = 2
Common Dial Clr
92 Select = 3
Msg Clr
92 Select = 4
Tmr Reminder Clr
92 Select = 5
DKT VR Initial
92 Select = 9
Back Up RAM Clr
92 Select = (1~0)
Data Programmed
LCD Response
No. N-N
06:43
Data Store
Strata DK Programming 5/00
1