Program *03 For Dk424 - Cabinet Type Identification - Toshiba DK14 Programming Manual

System & Station
Program *03 for DK424 – Cabinet Type Identification
Program *03 for DK424 – Cabinet Type Identification
Processor Type:
Program Type:
Initialized Default:
✱ ✱ ✱ ✱
SELECT =
(Cabinet No. 1~7)
1 (Base)
2 (1st Expansion)
3 (2nd Expansion)
4 (3rd Expansion)
5 (4th Expansion)
6 (5th Expansion)
7 (6th Expansion)
Program *03 - Overview
You must run this program when using the DK424 or DK280 RCTUE/F, or DK424i B5CAU/BU.
It identifies which type of cabinets are installed (DK424i, DK424 or DK280).
The RCTUE/F processor can be installed in a DK424 or DK280 base cabinet. The expansion
cabinets can be any combination of DK424 and DK280 - except the seventh expansion cabinet
must be a DK424.
The DK280 expansion cabinet can only support six universal PCB slots in any possible
configuration.
The DK424 expansion cabinet supports eight universal PCB slots only if the RCTUE/F is installed
in a DK424 base cabinet and the MBJU jumper is removed from the DK424 base cabinet
backplane. MBJU does not apply with DK424i cabinets.
Important!
3-12
RCTUE/F or B5CAU/B5CBU
System
All cabinets = 1
✱
SELECT = Cabinet No. (1~7)
CABINET = 1 or 2 (type)
Type 1 (DK424 or DK424i)
Type 2 (DK280)
Cabinet Type
(1 or 2)
1 only
This programs exists on DK424i B5CAU/BU processors. It must always be set to
Cabinet Type "1" allowing 10 slots for each DK424i Expansion Cabinet. DK280
and DK424 Expansion Cabinets cannot be used with DK424i processors.
Turn System Power Off (5 sec) then On.
Run Program 91-2
Expansion Cabinet Universal PCB Slot Availability
Case 1
RCTUE/F in DK424 Base Cabinet with MBJU removed
Expansion Cabinet (max 6)
DK424
DK280
Note
MBJU is not used with DK424i cabinets.
Case 2
RCTUE/F in DK280 Base Cabinet
Expansion Cabinet (max 5)
DK424
DK280
or...
Universal PCB Slots
1~8 available
1~6 available
Universal PCB Slots
1~6 available
1~6 available
Strata DK Programming 5/00