Toshiba DK14 Programming Manual page 263

LCR Example
The table below shows the actual dial output digits at the time that LCR sends them. These output
digits are determined by the settings for LEDs 01 and 02. In this example, the user dials
+ telephone number.
Program *45-4
LED 01 On
LED 01 Off
F-MDT = Added digits in Front of number dialed (Program 55-1)
E-MDT = Added digits at the End of number dialed (Program 55-2)
Code
Number = Dialed telephone number
9
Pause
Strata DK Programming 5/00
LED 02 On
Code + Pause + F-MDT + number + E-MDT
Code + F-MDT + number + E-MDT
= Digits programmed in Program *45-3
= LCR access code
= Pause time determined in Program 12-3
Program *45-4 – Special Code Dialing Sequence with LCR
LED 02 Off
F-MDT + Code + Pause + number + E-MDT
F-MDT + Code + number + E-MDT
Toll Restriction
+ code
4-29