Brocade Communications Systems Brocade 8/12c User Manual page 568

18
Adding target disk LUNs for encryption
FIGURE 236
8. Set the Current LUN State as required. If the LUN already has an existing key ID, the Current
9. If REPL Support was enabled by the Configure Switch Encryption wizard, a New LUN check box
10. Click Finish.
11. In environments where there are multiple paths to the same LUNs, it is critical that the same
524
Select LUN dialog box
LUN State field is automatically set to Encrypted. You can accept the automatically assigned
state or change this value if desired.
is presented and enabled by default. If this LUN is to be paired with another LUN for SRDF data
replication, the New LUN option must be enabled by selecting this check box. Refer to
"Metadata requirements and remote replication"
If REPL support was not enabled, this check box is not displayed.
The new LUN path is added to the Encryption Disk LUN View table.
LUN policies are configured on all instances of the LUN. Be sure to return to the Encryption
Disk LUN View dialog box to determine if there are configuration mismatches. Check under
Encryption Mode for any entries showing Mismatch. To correct the mismatch, click the
incorrect mode to display the options, then select the correct mode
for information about how this option works.
(Figure
Brocade Network Advisor SAN User Manual
237).
53-1002167-01