Selecting Source Address Products And Ports - Brocade Communications Systems Brocade 8/12c User Manual

30
Event action definitions
5. Enter the value of the varbind. The value you enter must conform to the data type required by
6. Click Next.

Selecting source address products and ports

The Sources pane of the Add Event Action dialog box, shown in
IP address, the world wide name, or the name of the source. Alternatively, you can select source
address products to use as event senders from the available list of sources. You can select from
the available list of SAN products, IP products, or Hosts by selecting the appropriate tab.
Perform the following steps to configure the identity of the source.
1. Select Monitor > Event Processing > Event Actions.
2. Click Next to advance to the Sources pane.
3. Select the Use Ifindex in source matching check box if you want to use ifIndex to filter traps on
4. If the Use IfIndex in source matching check box is selected, select the varbind to be used from
870
•
in – Matches collection
•
not_in – Does not match collection
•
~ – Arbitrary Unicode regular expression
the varbind. For example, if the varbind expects an integer and you enter a text string, your
entry will be rejected. Alternatively, you can select values from dropdown choices, as shown in
Figure 386.
The Sources pane of the Add Event Action Sources dialog box displays. Proceed to
source address products and ports"
FIGURE 387
Sources pane of the Add Event Action dialog box
The Event Actions dialog box displays.
a specific port of a product; otherwise, the filter is applied globally on a product.
the Trap Varbind (IfIndex) list.
on page 870.
Figure
Brocade Network Advisor SAN User Manual
"Selecting
387, allows you to enter the
53-1002167-01