Adding An Snmp V1 Or V2C Community String - Brocade Communications Systems Brocade 8/12c User Manual

30
SNMP traps
4. Type the user name in the User Name field.
5. Select an authentication protocol from the Auth Protocol list. You can select -None-,
6. Type a password in the Auth Password field and re-type the password in the Auth Confirm
7.
8. Type a password in the Priv Password field and re-type the password in the Confirm Priv
9. Click OK.

Adding an SNMP v1 or v2c community string

To add an SNMP v1 or v2c community string credential, complete the following steps:
1. Select Monitor > SNMP Setup > Event Reception.
2. Click the Accept SNMPv1/v2c traps with only these community strings button.
3. Click Add.
858
FIGURE 377 SNMP v3 Credentials dialog box
For configurations that do not have authentication or privacy, the Management application
uses the user name to match for authentication.
HMAC-MD5, or HMAC_SHA. HMAC_MD5 is the default.
If you select no authentication, the Management application uses the user name to match for
authentication.
Password field.
Select a privacy protocol from the Priv Protocol list. You can select -None-, CBC_DES, or
CFB_AES_128.
If you select no privacy, the Management application uses the user name to match for
authentication.
Password field.
The Event Reception dialog box displays.
The SNMP v1/v2c Community String dialog box, shown in Figure 378, displays.
Brocade Network Advisor SAN User Manual
53-1002167-01