Enabling Or Disabling The Fcoe Map On The Port - Brocade Communications Systems Brocade 8/12c User Manual

Enabling or disabling the FCoE map on the port

You must first manually disable an FCoE map-enabled port if you want to edit the VLAN ID of the
FCoE map. See
editing the VLAN ID using the Edit Switch dialog box, FCoE tab.
1. Select Configure > DCB from the menu bar.
2. Select a port and click Edit.
3. Click the FCoE tab on the Edit Port dialog box.
4. If enabled, click the Enable FCoE check box to disable the port's membership on the FCoE
5. When you have finished the configuration, click OK to launch the Deploy to Ports dialog box.
6. Click OK after changing the attributes of the current deployment.
7.
Brocade Network Advisor SAN User Manual
53-1002167-01
"Changing the VLAN ID on the default FCoE map"
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
The Edit Port dialog box, FCoE tab displays, as shown in
FIGURE 128
Edit Port dialog box - FCoE tab
map.
The Deployment Status dialog box launches.
Click Start on the Deployment Status dialog box to save the changes to the selected devices.
FCoE provisioning
on page 360 for information on
Figure 128.
14
361