Brocade Communications Systems Brocade 8/12c User Manual page 897

4. Enter a general description of the trap destination in the Description field.
5. Enter the IP address of the trap destination in the IP Address field. This is a mandatory field.
6. Enter the SNMP trap listening port of the recipient in the Port # field. This is a mandatory field.
7.
8. Click the Add Source Address check box.
9. Click the SNMP Trap Repeater check box. When enabled, all traps, whether the source is
10. Select the trap forwarding type from the list. Supported SNMP types are v1, v2c, and v3.
11. You can choose not to select a filter (zero), or you can select up to five filters from the Available
12. Click OK.
Brocade Network Advisor SAN User Manual
53-1002167-01
FIGURE 374 Add Trap Destination dialog box
IPv4 and IPv6 addresses are accepted but a DNS name is not accepted.
Valid numeric values range from 1 through 65535.
Click the Enable check box to enable trap forwarding.
managed or unmanaged, are forwarded. When disabled, only traps from the selected products
are forwarded.
Filters list. Click the right arrow button to move them to the Selected Filters list.
30
SNMP traps
853