Brocade Communications Systems Brocade 8/12c Reference page 233

Object and OID
connUnitPortControl
1.3.6.1.3.94.1.10.1.16
Fabric OS MIB Reference
53-1002151-01
Access Description
Read-write Controls the addressed connUnit's port.
Valid commands are:
resetConnUnitPort
If the addressed connUnit allows this operation to be performed to this
port, the addressed port performs a vendor-specific reset operation.
Examples of these operations are:
•
The Link Reset protocol.
•
The Loop Initialization protocol.
•
Resynchronization occurring between the transceiver in the
addressed port to the transceiver to which the port is connected.
bypassConnUnitPort
If the addressed connUnit allows this operation to be performed to this
port, the addressed port performs a vendor-specific "bypass" operation.
Examples of these operations are:
•
Transitioning from online to offline.
•
A request (NON-PARTICIPATING) command to the loop port state
machine.
•
Removal of the port from an arbitrated loop by a hub.
unbypassConnUnitPort
If the addressed connUnit allows this operation to be performed to this
port, the addressed port performs a vendor-specific "unbypass"
operation. Examples of these operations are:
•
The Link Failure protocol.
•
A request (PARTICIPATING) command to the loop port state
machine.
•
Addition of the port to an arbitrated loop by a hub.
offlineConnUnitPort
If the addressed connUnit allows this operation to be performed to this
port, the addressed port performs a vendor-specific offline operation.
Examples of these operations are:
•
Disabling a port's transceiver.
•
The Link Failure protocol.
•
Request (NON-PARTICIPATING) command to the loop port state
machine removal of the port from an arbitrated loop by a hub.
onlineConnUnitPort
If the addressed connUnit allows this operation to be performed to this
port, the addressed port performs a vendor-specific online operation.
Examples of these operations are:
•
Enabling a port's transceiver.
•
The Link Failure protocol, request (PARTICIPATING) command to the
loop port state machine.
•
Addition of the port from an arbitrated loop by a hub.
Each implementation might choose not to allow any or all of these
values on a SET.
If the management station uses in-band communication (FC-IP)
with the switch, either of the two following actions might result in a
loss of in-band communication with the switch.
•
Disabling the FC port that is connected to the management
station
•
Disabling the embedded port
Connectivity unit group
9
213