Tftp Client Ipv6 Dscp; Tftp Client Source - HP 6125G Command Reference Manual

Use undo tftp client dscp to restore the default.
By default, IPv4 uses the DSCP value 0 for outgoing TFTP packets on a TFTP client.
Examples
# Set the DSCP value for IPv4 to use for outgoing TFTP packets to 30 on a TFTP client.
<Sysname> system-view
[Sysname] tftp client dscp 30

tftp client ipv6 dscp

Syntax
tftp client ipv6 dscp dscp-value
undo tftp client ipv6 dscp
View
System view
Default level
2: System level
Parameters
dscp-value: Specifies a DSCP value in the range of 0 to 63.
Description
Use tftp client ipv6 dscp to set the DSCP value for IPv6 to use for outgoing TFTP packets on a TFTP client.
Use undo tftp client ipv6 dscp to restore the default.
By default, IPv6 uses the DSCP value 0 for outgoing TFTP packets on a TFTP client.
Examples
# Set the DSCP value for IPv6 to use for outgoing TFTP packets to 30 on a TFTP client.
<Sysname> system-view
[Sysname] tftp client ipv6 dscp 30

tftp client source

Syntax
tftp client source { interface interface-type interface-number | ip source-ip-address }
undo tftp client source
View
System view
Default level
2: System level
Parameters
interface interface-type interface-number: Specifies the source interface for establishing TFTP
connections. The primary IP address of the source interface is used as the source IP address of packets
83