Display Nandflash Badblock-Location - HP 6125G Command Reference Manual

chunk(1)
chunk(2)
filename: test.cfg
Table 12 Command output
Field
Logic Chunk
Physical Page
chunk(0)

display nandflash badblock-location

Syntax
display nandflash badblock-location [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display nandflash badblock-location to display the number and location of bad blocks in the NAND
Flash memory.
Examples
# Display the number and location of bad blocks in the NAND Flash memory.
<Sysname> display nandflash badblock-location
No
------------------------------
badblock(0)
badblock(1)
badblock(2)
3200 block(s) total, 3 block(s) bad.
1236
1235
Description
Serial number of the logical pages.
Serial number of the physical pages.
The first logical page of this file corresponds to the 1234th physical page
1234
on the device.
Physical block
1234
1235
1236
91