Ftp Ipv6; Get - HP 6125G Command Reference Manual

[Sysname] ftp client source interface vlan-interface 1

ftp ipv6

Syntax
ftp ipv6 [ server-address [ service-port ] [ source ipv6 source-ipv6-address ] [ -i interface-type
interface-number ] ]
View
User view
Default level
3: Manage level
Parameters
server-address: IP address or host name of the remote FTP server.
service-port: TCP port number of the FTP server, in the range of 0 to 65535. The default value is 21.
source ipv6 source-ipv6-address: Specifies a source IPv6 address for transmitted FTP packets. This
address must be an IPv6 address that has been configured on the device.
-i interface-type interface-number: Specifies an output interface by its type and number. This parameter
can be used only when the FTP server address is a link local address and the specified output interface
has a link local address. For the configuration of link local addresses, see Layer 3—IP Services
Configuration Guide.
Description
Use ftp ipv6 to log in to the FTP server and enter FTP client view.
This command applies to IPv6 networks only.
If you use this command without specifying any parameters, you will simply enter the FTP client view
without logging in to an FTP server.
If you specify the parameters, enter the username and password for accessing the FTP server.
Examples
# Log in to the FTP server with IPv6 address 3000::200.
<Sysname> ftp ipv6 3000::200
Trying 3000::200 ...
Press CTRL+K to abort
Connected to 3000::200.
220 Welcome!
User(3000::200:(none)): MY_NAME
331 Please specify the password.
Password:
230 Login successful.
[ftp]

get

Syntax
get remotefile [ localfile ]
68