Qinq Ethernet-Type Service-Tag - HP 6125G Command Reference Manual

Table 46 Common protocol type values
Protocol type
ARP
PUP
RARP
IP
IPv6
PPPoE
MPLS
IPX/SPX
IS-IS
LACP
802.1X
Cluster
Reserved
Description
Use qinq ethernet-type customer-tag to configure the TPID value in CVLAN tags.
Use undo qinq ethernet-type customer-tag to restore the TPID value in CVLAN tags to the system default.
By default, the TPID value in CVLAN tags is 0x8100.
On a port with basic QinQ enabled, the switch judges whether a frame is VLAN tagged based on the
CVLAN TPID value globally configured.
Examples
# Set the TPID value in the CVLAN tags to 0x8200 globally.
<Sysname> system-view
[Sysname] qinq ethernet-type customer-tag 8200

qinq ethernet-type service-tag

Syntax
qinq ethernet-type service-tag hex-value
undo qinq ethernet-type service-tag
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
hex-value: Hexadecimal TPID value, ranging from 0x0001 to 0xFFFF. However, do not set it to any of the
protocol type values listed in Table 46.
196
Value
0x0806
0x0200
0x8035
0x0800
0x86DD
0x8863/0x8864
0x8847/0x8848
0x8137
0x8000
0x8809
0x888E
0x88A7
0xFFFD/0xFFFE/0xFFFF