Parameters
None
Description
Use check region-configuration to display MST region pre-configuration information, including the
region name, revision level, and VLAN-to-instance mapping settings.
Two or more spanning tree devices belong to the same MST region only if they are configured with the
same format selector (0 by default, not configurable), MST region name, MST region revision level, and
the same VLAN-to-instance mapping entries in the MST region, and if they are connected via a physical
link.
HP recommends that you use this command to determine whether the MST region configurations to be
activated are correct. Activate them only when they are correct.
Related commands: instance, region-name, revision-level, vlan-mapping modulo, and active
region-configuration.
Examples
# Display MST region pre-configurations.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] check region-configuration
Admin Configuration
Format selector
Region name
Revision level
Configuration digest :0x41b5018aca57daa8dcfdba2984d99d06
Instance
0
15
Table 22 Command output
Field
Format selector
Region name
Revision level
Instance Vlans Mapped
display stp
Syntax
display stp [ instance instance-id ] [ interface interface-list | slot slot-number ] [ brief ] [ | { begin |
exclude | include } regular-expression ]
View
Any view
:0
:000fe26a58ed
:0
Vlans Mapped
1 to 9, 11 to 4094
10
Description
Format selector of the MST region, which is 0 (not configurable).
MST region name.
Revision level of the MST region.
VLAN-to-instance mappings in the MST region.
88