HP 6125G Command Reference Manual page 15

<Sysname> display interface gigabitethernet 1/0/1
GigabitEthernet1/0/1 current state: DOWN
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000f-e2d2-58fb
Description: GigabitEthernet1/0/1 Interface
Loopback is not set
Media type is not sure,Port hardware type is No connector
1000Mbps-speed mode, full-duplex mode
Link speed type is force link, link duplex type is force link
Flow-control is enabled
The Maximum Frame Length is 9216
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 1
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Port priority: 0
Last clearing of counters:
Peak value of input: 0 bytes/sec, at 2000-06-13 15:27:44
Peak value of output: 0 bytes/sec, at 2000-06-13 15:27:44
Last 300 seconds input:
Last 300 seconds output:
Input (total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Input (normal): 0 packets, - bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Input: 0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
Output (total): 0 packets, 0 bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Output (normal): 0 packets, - bytes
0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
Table 3 Command output
Field
GigabitEthernet1/0/1 current state
IP Packet Frame Type
Hardware address
Description
Never
0 packets/sec 0 bytes/sec 0%
0 packets/sec 0 bytes/sec 0%
Description
Physical state of the Ethernet interface. For more information, see
4.
Ethernet framing format on the interface.
Hardware address of the port.
Description of the interface.
7
Table