Bpdu-Tunnel Tunnel-Dmac - HP 6125G Command Reference Manual

You cannot enable BPDU tunneling on a member port of a service loopback group.
Before enabling BPDU tunneling for DLDP, EOAM, GVRP, HGMP, LLDP, or STP on a port, disable the
protocol on the port first.
To enable BPDU tunneling for PVST (which is a spanning tree protocol) on a port, disable STP first and
then enable BPDU tunneling for STP on the port.
Do not enable BPDU tunneling for DLDP, EOAM, LACP, LLDP, PAGP, or UDLD on the member port of a
Layer 2 aggregation group.
Examples
# Disable STP on GigabitEthernet 1/0/1, and then enable BPDU tunneling for STP on the port.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo stp enable
[Sysname-GigabitEthernet1/0/1] bpdu-tunnel dot1q stp
# Disable STP on Layer 2 aggregate interface Bridge-Aggregation 1, and then enable BPDU tunneling
for STP on the Layer 2 aggregate interface.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] undo stp enable
[Sysname-Bridge-Aggregation1] bpdu-tunnel dot1q stp

bpdu-tunnel tunnel-dmac

Syntax
bpdu-tunnel tunnel-dmac mac-address
undo bpdu-tunnel tunnel-dmac
View
System view
Default level
2: System level
Parameters
mac-address: Specifies a destination multicast MAC address for BPDUs, in the format of H-H-H. The
allowed values are 0x0100-0CCD-CDD0, 0x0100-0CCD-CDD1, 0x0100-0CCD-CDD2, and
0x010F-E200-0003.
Description
Use bpdu-tunnel tunnel-dmac to configure the destination multicast MAC address for BPDUs.
Use undo bpdu-tunnel tunnel-dmac to restore the default value.
By default, the destination multicast MAC address for BPDUs is 0x010F-E200-0003.
Examples
# Set the destination multicast MAC address for BPDUs to 0x0100-0CCD-CDD0.
<Sysname> system-view
[Sysname] bpdu-tunnel tunnel-dmac 0100-0ccd-cdd0
129