HP 6125G Command Reference Manual page 13

View
Any view
Default level
1: Monitor level
Parameters
inbound: Displays inbound traffic rate statistics.
outbound: Displays outbound traffic rate statistics.
interface-type: Specifies an interface type.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display counters rate to display traffic rate statistics over the last sampling interval.
The statistics cover only interfaces in up state. If an interface type is specified, the command displays
traffic rate statistics for all up interfaces of the specified type. If no interface type is specified, the
command displays traffic rate statistics for all up interfaces that have traffic counters.
To set the statistics polling interval, use the flow-interval command. The default statistics polling interval
is five minutes.
Related commands: flow-interval.
Examples
# Display the inbound traffic rate statistics for all GigabitEthernet interfaces.
<Sysname> display counters rate inbound interface gigabitethernet
Interface
GE1/0/1
GE1/0/2
GE1/0/3
Overflow: more than 14 decimal digits.
--: not supported.
Table 2 Command output
Field
Interface
Total (pkts/sec)
Broadcast (pkts/sec)
Total(pkts/sec) Broadcast(pkts/sec)
200
300
300
Description
Abbreviated interface name.
Average rate (in packets per second) of receiving or sending packets during
the sampling interval.
Average rate (packets per second) of receiving or sending broadcast packets
during the sampling interval.
5
Multicast(pkts/sec)
100
200
200
100
100
100