Revision-Level - HP 6125G Command Reference Manual

Description
Use reset stp to clear the MSTP statistics.
The MSTP statistics include the numbers of TCN BPDUs, configuration BPDUs, RST BPDUs and MST
BPDUs sent/received through the specified ports. The STP BPDUs and TCN BPDUs are counted only for
the CIST.
If you specify the interface-list argument, the reset stp command clears the spanning tree-related statistics
on the specified ports. Without the argument, the reset stp command clears the spanning tree-related
statistics on all ports.
Related commands: display stp.
Examples
# Clear the spanning tree-related statistics on ports GigabitEthernet 1/0/1 through GigabitEthernet
1/0/3.
<Sysname> reset stp interface gigabitethernet 1/0/1 to gigabitethernet 1/0/3

revision-level

Syntax
revision-level level
undo revision-level
View
MST region view
Default level
2: System level
Parameters
level: Specifies an MSTP revision level, in the range of 0 to 65535.
Description
Use revision-level to configure the MSTP revision level.
Use undo revision-level to restore the default MSTP revision level.
By default, the MSTP revision level is 0.
The MSTP revision level, the MST region name, and the VLAN-to-instance mapping table of a device
determine the device's MST region. When the MST region name and VLAN-to-instance mapping table
are both the same for two MST regions, they can still be differentiated by their MSTP revision levels.
After configuring this command, run the active region-configuration command to activate the configured
MST region level.
Related commands: instance, region-name, vlan-mapping modulo, display stp region-configuration,
check region-configuration, and active region-configuration.
Examples
# Set the MSTP revision level of the MST region to 5.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] revision-level 5
105