View
System view
Default level
2: System level
Parameters
count: Sets the number of the LLDPDUs sent each time fast LLDPDU transmission is triggered. The
argument ranges from 1 to 10.
Description
Use lldp fast-count to set the number of the LLDPDUs sent each time fast LLDPDU transmission is triggered.
Use undo lldp fast-count to restore the default.
By default, the number is 3.
Examples
# Configure the device to send four LLDPDUs each time fast LLDPDU transmission is triggered.
<Sysname> system-view
[Sysname] lldp fast-count 4
lldp hold-multiplier
Syntax
lldp hold-multiplier value
undo lldp hold-multiplier
View
System view
Default level
2: System level
Parameters
value: Sets the TTL multiplier, ranging from 2 to 10.
Description
Use lldp hold-multiplier to set the TTL multiplier.
Use undo lldp hold-multiplier to restore the default.
By default, the TTL multiplier is 4.
You can set the TTL of the local device information by configuring the TTL multiplier.
The TTL configuration of a device is determined by the following expression:
TTL multiplier × LLDPDU transmit interval
The TTL can be up to 65535 seconds. Longer TTLs will be rounded off to 65535 seconds.
Related commands: lldp timer tx-interval.
Examples
# Set the TTL multiplier to 6.
219