Setting A Subnet Mask At The Control Panel; Setting Default Gateway At The Control Panel - Xerox PHASER 5400 Advanced Features And Troubleshooting Manual

Networking

Setting a Subnet Mask at the control panel

Note
Setting a Subnet Mask can also be accomplished in CentreWare DP, CentreWare
MC, or CentreWare IS. Refer to page 46 for more information.
Using Subnet Mask allows the printer to use bits from the network address and apply it to
the host address. The IP Address Res menu item in the Ethernet Menu must be set to static
before a Subnet Mask can be set.
1. Press Menu Up or Menu Down until you see:
Menus
Ethernet Menu
2. Press Item Up or Item Down until you see:
Ethernet Menu
Subnet Mask
3. Press Value Up or Value Down. You should see:
Subnet Mask
xxx.xxx.xxx.xxx
Press Value Up or Value Down to change the value of the character above the cursor.
4.
The value is incremented or decremented by 1 each time the key is pressed. Holding
down Value Up or Value Down causes continuous scrolling through the values.
5. To change other characters in the Subnet Mask, press Item Up or Item Down to scroll
right or left respectively through the character string, then press Value Up or Value
Down to change the value of the character above the cursor (as in Step 4).
6. When you have completed setting the Subnet Mask, press Enter. You should see:
Ethernet Menu
Subnet Mask
7. Press On Line. You should see:
Ready

Setting Default Gateway at the control panel

Note
Setting a Default Gateway can also be accomplished in CentreWare DP,
CentreWare MC, or CentreWare IS. Refer to page 46 for more information.
The IP Address Res menu item in the Ethernet Menu must be set to static before a Default
Gateway can be set.
Press Menu Up or Menu Down until you see:
1.
Menus
Ethernet Menu
2. Press Item Up or Item Down until you see:
Ethernet Menu
Default Gateway
62
=
Xerox Phaser 5400 Laser Printer