Xerox PHASER 5400 Advanced Features And Troubleshooting Manual page 106

Control Panel Messages
Error Description and corrective action
Open/Extend MBF Appears following an initial paper jam message.


Open/Extend MBF Appears following an initial paper jam message.
Open Top Cover


Open/Extend MBF A paper jam has occurred while feeding from the Multi-sheet Bypass Feeder.
Remove All Paper


Load <tray> The specified tray may be out of the requested paper, or the printer is not
<size> <type> configured for the requested paper. (The
System Menu
condition.)








Low Paper-MBF or The amount of paper in the MBF or indicated tray is low and will soon need
Low Paper-Tray n to be replenished.
Maintenance Kit The Fuser and Bias Transfer Roll (BTR) have reached their end of life.
Replace


Manual Feed The paper required for the job needs to be loaded in the Multi-sheet Bypass
<Size> <Type> Feeder.


Memory Failure The printer controller memory has failed; printing cannot resume.
Power Off/On




Menu Locked A sub-menu has been locked and the user is prohibited from making any
changes to the configuration parameters in the sub-menu.


Motor Failure The printer motor has failed; printing cannot resume.
Power Off/On




No Jobs The Password Menu has been invoked, a password has been entered, and
Press Menu there are no secure jobs with this password in the print queue.
90
Open the MBF door, then lift up and pull out the Multi-sheet Bypass
Feeder. Refer back to the control panel for further messages.
Open the MBF door, then lift up and pull out the Multi-sheet Bypass
Feeder. Open the printer's top cover, then refer back to the control panel
for further messages.
Open the MBF door, then lift up and pull out the Multi-sheet Bypass
Feeder. Remove all the paper, then refer back to the control panel for
further messages.
determines whether to wait or ignore a mismatch
If the specified tray is out of the requested paper, load paper of the
requested size and type in that tray. Printing continues.
If the requested paper was not loaded in the printer at all (none of the trays
were configured for that paper size and type), load the requested paper in
the specified tray.
If you do not want to load the requested paper in that tray but want to use
another tray, load the requested paper in the other tray, then use the
on the control panel to match the requested paper type.
Menu
If you decide to use another paper size or type for the job, press the
Value keys (labeled 3 or 7) to scroll through all the trays until you find an
acceptable alternate, then press the Enter key (labeled 4). Printing
continues on the new paper, but data can be lost (off the page) or not
formatted correctly when you change paper size/type.
Install a new Maintenance Kit.
Add paper of the requested size and type to the Multi-sheet Bypass Feeder.
Perform a Memory Check by powering OFF the printer, then powering it
ON again.
If the problem persists, contact your Customer Support Center.
The menu can only be unlocked with a PJL command or SNMP tool, such
as CentreWare DP or through CentreWare Internet Services.
Power OFF and ON the printer.
If the problem persists, contact your Customer Support Center.
setting in the
Page Policy
Xerox Phaser 5400 Laser Printer
Tray