Xerox PHASER 5400 Advanced Features And Troubleshooting Manual page 29

Tray Menu Items (cont'd.)
Custom Y Specifies the Y dimension of the paper loaded in any trays in Custom Mode.
Y direction is front-to-back in the tray.
Values:
98 mm (3.87 in.)
508 mm (20 in.)
279 mm (11 in.)
Note: This parameter is not visible in the menu unless
Custom
Tray N Mode Determines whether or not the tray's auto size detection mechanism is
overridden by custom size settings (where N is the tray number - Tray 1, 2,
or 3).
Values:
Config Fuser The fusing system of the Xerox Phaser 5400 laser printer can be adjusted to
accommodate various types of special print media:


When the
types are available as a menu item (also in the
the user to set fuser temperatures appropriately to match the requirements of
each media type.
The following settings are available:
Fuser Setting
Normal
Low
High
Fuser temperatures can be set for each paper type from the control panel,
except Transparency (it is always on Low Temperature).
For optimum results, temperature settings are usually based on the weight of
the paper stock.
Once the desired fuser settings have been stored for each media type, the
procedure for printing on special media is as follows:






Advanced Features and Troubleshooting Manual
minimum
maximum
(default)
is set to .
On
(default)
Auto
Custom
The fusing temperature can be varied to match the requirements of the
media.
Config Fuser
Description
Normal Temperature
Low Temperature
High Temperature
Load the special media into a paper tray.
Set to match the special media loaded in the tray.
Tray Type
From the driver properties screen, choose
to match the type of special media loaded in the tray.
selection in the
Tray Menu
Tray Menu
Examples of Usage
Ordinary Plain Paper
Plastic Label
Card Stock
Select Paper
Control Panel Menus
Configure
is set to , media
On
). This enables
, then set
Type
13