Xerox PHASER 5400 Advanced Features And Troubleshooting Manual page 28

Control Panel Menus
Tray Menu Items (cont'd.)
Tray Sequence Defines the order in which trays are used when more than one tray meets the
size and type requirements.
The first tray of a sequence is used (if it has the correct paper size/type) until
it runs out of paper, at which time the next tray in the sequence is used (if it
has the correct paper size/type). Refer to page 41 for more information on
automatic tray switching.
Values:
Note: Only the trays that are installed in the printer appear in the tray
sequence.
If the value is set to
by the user in the print driver, even if the other trays contain the correct
stock for that job.
Configure Custom Allows access to the setting of custom paper sizes. If this parameter is OFF,
the following entries are not visible: Custom Units, Custom X, and Custom Y.
Values:
Custom Units Specifies the units used to set custom paper size dimensions.
Values:
Note: When set to
default MBF Size is set to
Letter
When set to
default MBF Size is set to
default Envelope Size is set to
Custom X Specifies the X dimension of the paper loaded in any trays in Custom Mode.
X direction is left-to-right in the tray.
Values:
76 mm (3.0 in.)
305 mm (12 in.)
216 mm (8.5 in.)
Note: This parameter is not visible in the menu unless
Custom
12
(no tray switching)
Off
(default when no optional trays installed)
MBF-1
MBF-2
MBF-3
MBF-1-2
MBF-1-2-3
(default with only Tray 2 installed)
MBF-2-1
MBF-2-3
MBF-3-1
(default with Trays 2 and 3 installed)
MBF-3-1-2
MBF-3-2
1-MBF
1-2
1-2-3
2-1
2-3
3-1
3-1-2
3-2
, the printer will print only from the tray requested
Off
(default)
Off
On
Inches
Millimeters
, the default Paper Size value is
Inches
Letter
; and the default Envelope Size is set to
Millimeters
A4
minimum
maximum
(default)
is set to .
On
; the default Custom Size is set to
Com10
, the default Paper Size value is set to
; the default Custom Size is set to
.
DL
Xerox Phaser 5400 Laser Printer
; the
Letter
.
; the
A4
; and the
A4
Configure