Xerox PHASER 5400 Advanced Features And Troubleshooting Manual page 109

Error Description and corrective action
Stacker Jam- A paper jam has occurred at the Stacker Bin.
Open Rear Cover


Toner Low Toner is getting low in the Laser Print Cartridge. Printing will continue
without interruption until the cartridge is empty.


Tray 1 Jam- A paper jam has occurred at or before the input sensor when feeding from
Open Tray 1 Tray 1.


Tray 2 Failure Tray 2 has failed.
Power Off/On








Tray 2 Jam- A paper jam has occurred at or before the input sensor when feeding from
Open Tray 2 Tray 2.






Tray 2/3 Failure Tray 2 or Tray 3 has failed.
Power Off/On








Tray 3 Failure Tray 3 has failed.
Power Off/On








Tray 3 Jam-


Open Tray 3






Tray 2 Lifting The specified tray has been refilled, is rising into position and will soon be
or ready for printing.
Tray 3 Lifting
Tray n Empty The specified tray is empty and should be refilled. The job has not stopped
printing yet, because the printer has switched to another input tray that
contains paper.
Waiting... The printer was busy processing data from a host but the print job was not
completed.
This message appears until another print job is received, the Port Timeout
expires, the last page timeout expires, or the PostScript "waittimeout"
expires.
Advanced Features and Troubleshooting Manual
Open the rear printer cover, then refer back to the control panel for further
messages.
Replace the cartridge as soon as possible.
Remove Tray 1 from the printer, then refer back to the control panel for
further messages.
Power OFF the printer.
Reinstall the Tray 2 Feeder.
Power ON the printer.
If the problem persists, contact your Customer Service Center.
If Tray 2 is a 500-Sheet Feeder, remove Tray 2 from the printer.
If Tray 2 is the 2,000-Sheet Feeder, open the feeder's paper tray.
Refer back to the control panel for further messages.
Power OFF the printer.
Reinstall the 500-Sheet Feeders for Tray 2 and Tray 3.
Power ON the printer.
If the problem persists, contact your Customer Service Center.
Power OFF the printer.
Reinstall the Tray 3 Feeder.
Power ON the printer.
If the problem persists, contact your Customer Service Center.
A paper jam has occurred at or before the input sensor when feeding paper
from Tray 3.
If Tray 3 is a 500-Sheet Feeder, remove Tray 3 from the printer.
If Tray 3 is the 2,000-Sheet Feeder, open the feeder's paper tray.
Refer back to the control panel for further messages.
Control Panel Messages
93