Xerox PHASER 5400 Advanced Features And Troubleshooting Manual page 108

Control Panel Messages
Error Description and corrective action
Print Using The available paper size or type does not match what was requested and the
<size> <type> Value key (labeled 3 or 7) was pressed.


Processing... A job is being processed with the specified name.
<Job Name>
Processing... A Configuration Sheet is being printed.
Config Sheet
Processing... A Demo Page is being printed.
DEMO
Processing... The Hard Drive Directory Report is being created and printed.
Disk Directory
Processing... The printer is printing a flash DIMM directory.
Flash Directory
Processing... The printer is generating and printing a fault history log.
Fault History
Processing... A list of the control panel menu structure is being printed.
Menu Map
Processing... A PCL Font List is being printed.
PCL Font List
Processing... A PostScript Font List is being printed.
PostScript
Processing... A Test Page is being printed.
TEST
Processing... The specified tray is being used.
Tray n
Ready The printer is online and waiting for data to print.
Remove Output The Stacker Bin is full.
From Stacker Bin


Remove Output The Standard Bin is full.
From Std. Bin


Remove Print Cart


Clear Paper Path




Replace Print The Laser Print Cartridge has reached its end of life. Printing cannot resume.
Cartridge


Stacker Bin Fail The Stacker Bin is not set normally or has failed. Printing using this bin
Power Off/On cannot resume.








92
Use the Value keys to search the trays. When you find an available size and
type of paper that is acceptable, press the Enter key (labeled 4). Back out of
the menu to exit. If the paper size and type that was substituted is not
acceptable, load the requested paper size and type, and print the job again.
Remove the output from the Stacker Bin.
Remove the output from the Standard Bin.
Appears following an initial paper jam message.
The Print Cartridge should be removed, if necessary, and the jammed paper
removed.
Close all covers and trays, then refer back to the control panel for further
messages.
Replace the cartridge.
Power OFF the printer.
Reinstall the Stacker Output Bin.
Power ON the printer.
If the problem persists, contact your Customer Support Center.
Xerox Phaser 5400 Laser Printer