Xerox PHASER 5400 Advanced Features And Troubleshooting Manual page 33

System Menu Items (cont'd.)
Policy Timeout Specifies how many seconds the printer should wait before taking the action
defined by the setting of the Page Policy item.
Values: (in seconds)
Print Quantity Specifies number of copies of each page.
Values:
Note: The number changes incrementally by 1 each time you press either the
Value key (labeled 3 or 7). To scroll quickly through the numbers, hold
down either key.
Duplex Enables/disables duplex printing for PostScript and PCL jobs. (This menu
item only appears if the printer has the Duplex Module installed.)
Values:
Note: For more information on duplex printing and choosing Long Edge or
Short Edge, see Printing two-sided (duplex) jobs in the User Guide.
Draft Mode Enables/disables Draft Mode, which reduces the amount of toner by up to
two-thirds (and prints a draft-quality output). Intended for occasional (not
continuous) use.
Values:
Note: This item is visible when the resolution value is 600x600.
PCL Edge-to-Edge Enables/disables edge-to-edge printing for PCL.
Values:
Note: Although the printer can address edge-to-edge, there is a 4 mm border
on all sides where print quality cannot be guaranteed.
PS Edge-to-Edge Enables/disables edge-to-edge printing for PostScript.
Values:
Note: Although the printer can address edge-to-edge, there is a 4 mm border
on all sides where print quality cannot be guaranteed.
Resolution Sets the default resolution for PCL6 and PostScript jobs. (PCL5e is always set
to 600x600).
Values:
Advanced Features and Troubleshooting Manual
300
180
120
60
(default)
30
0
- (default is )
1 999 1
(default)
Off
Long Edge
Short Edge
(default)
Off
On
(default)
Off
On
Off
(default)
On
(default)
600x600
1200 Quality
1200x1200
Control Panel Menus
17