Xerox PHASER 5400 Advanced Features And Troubleshooting Manual page 39

Ethernet Menu Items (cont'd.)
Subnet Mask Sets the four byte Subnet Mask address. (This menu item only appears if
Address Res
Values:
Note: Once the control panel shows
Value keys (labeled 3 or 7) to scroll to the desired value at the cursor
location. To move the cursor, use the Item keys (labeled 2 or 6). Thus, you
can change characters within the address rather than having to re-enter the
entire address.
Default Gateway Sets the four byte Default Gateway address. (This menu item only appears if
IP Address Res
Values:
This item only appears if IP Address Res. is set to
Note: Once the control panel shows
use the Value keys (labeled 3 or 7) to scroll to the desired value at the cursor
location. To move the cursor, use the Item keys (labeled 2 or 6). Thus, you
can change characters within the address rather than having to re-enter the
entire address.
Port Timeout Sets the time for determining when to end an incomplete print job and poll
the next port in the polling sequence. This menu item also causes an implicit
job end (such as Control D in PostScript or <ESC> E in PCL) and invokes the
emulation functions associated with this action (e.g., formfeed, reset, etc.).
Values (in seconds):
The value changes by 1 each time you press either Value key (labeled 3 or
7). Hold down either key to scroll quickly through the values.
Speed Sets the speed and half/full duplex mode of the 10/100 BaseT Ethernet
interface.
Values:
DDNS Enable Allows the printer to pass its Fully Qualified Domain Name (FQDN) to the
Dynamic Host Control Protocol (DHCP) server.
Values:
9100 Timeout Sets whether timeout is observed for the AppSocket Port 9100
communications protocol.
Values:
Advanced Features and Troubleshooting Manual
is set to
static
xxx.xxx.xxx.xxx
where = to
xxx 000 255
is set to
xxx.xxx.xxx.xxx
where = to
xxx 000 255
- (default is )
5 300 60
(default)
Auto
10/Half
10/Full
100/Half
100/Full
(default)
On
Off
(default)
On
Off
Control Panel Menus
.)
on the top line, use the
Subnet Mask
.)
static
Static
Default Gateway
IP
.
on the top line,
23