Xerox PHASER 5400 Advanced Features And Troubleshooting Manual page 104

Control Panel Messages
Error Description and corrective action
Demo Mode Appears when using the Reset Menu.






Disk Error A general failure (such as read/write) of the hard disk has occurred.
Format Disk




Disk Full A secure, proof, or download job spooled to the disk exceeds the available
free space on the hard disk. The job will be cancelled and deleted after part
of the first copy is printed. The job is cancelled and deleted after printing the
first copy of the partial job.


Download Failed A problem occurred while downloading printer operating code. Printing
Please Reboot may continue after rebooting.


Download Passed The downloading process has passed and the printer must be rebooted for
Please Reboot changes to take effect.


Downloading The printer is being loaded with new operating code.
Please Wait


Duplex Jam- Open A paper jam has occurred in the Duplex Module.
Rear Cover


Duplex Unit Fail The Duplex Module has failed or is not installed properly. Printing from the
or Removed Duplex Module cannot continue.




Enter Password Appears when using the Password Menu to print or delete secure and proof
_xxx jobs. Jobs Print or Jobs Delete.




Exit Jam- Open A paper jam has occurred at the exit path to an output bin.
Rear & Top Cover


Fan Failure The fan is not working.
Power OFF NOW!


Flash Error A Flash Memory error was found.
Format Flash




88
Press the Value keys (labeled 3 or 7) to toggle between
Select and press the Enter key (labeled 4) to enter printer
Yes
demonstration mode.
Select and press the Enter key to exit without entering printer
No
demonstration mode.
Power OFF and ON the printer.
If this message appears again at Power ON, contact your Customer Support
Center.
Delete fonts, macros, or secure and proof jobs to make space on the hard
disk.
Reboot and try downloading again.
Reboot the printer.
Please wait.
Open the printer's rear cover, then refer back to the control panel for
further messages.
Remove and re-install the Duplex Module.
If the Duplex Module still fails, contact your Customer Support Center.
Enter a valid 4-digit password using the control panel's keys, then proceed
to print or delete the secure and proof jobs that have that password.
If you want to exit the Password menu, press the Menu keys (labeled 1 or
5). To exit the menu system, press the On Line key (labeled 0).
Open the printer's rear and top covers, then refer back to the control panel
for further messages.
Power OFF the printer immediately and contact your Customer Support
Center.
Format flash memory as per the instructions on page 53.
If the problem persists, contact your Customer Service Center.
and
Yes No
Xerox Phaser 5400 Laser Printer
.