Diagnostics Mode
To run the printer diagnostic tests described in this chapter, put the printer in Diagnostics Mode.
The tests display on the operator panel in the order shown:
•
REGISTRATION
•
ALIGNMENT
•
TOP FINE MAR ADJ
•
MISC TESTS
•
PRINT TESTS
•
HARDWARE TESTS
•
DUPLEX TESTS (if duplex is installed)
•
INPUT TRAY TESTS
•
OUTPUT BIN TESTS
•
FINISHER TESTS (if finisher is installed)
•
BASE SENSOR TEST
•
DEVICE TESTS (if optional flash or disk installed)
•
PRINTER SETUP
•
EP SETUP
•
ERROR LOG
•
Exit Diagnostics
Entering Diagnostics Mode
To enter the Diagnostics Mode:
1.
Turn the printer off.
2.
Press and hold the Go and Return buttons.
3.
Turn the printer on.
Release the buttons when Performing Self Test is displayed.
4.
Exiting Diagnostics Mode
Select Exit Diagnostics to exit the Diagnostics Mode and return to normal mode.
5060-00x
3-13
Diagnostic aids